Natural Stone Sealer - 'WET LOOK' - Apply Fine Coats by Sprayer, Sponge or Cloth **Not Suitable for Polished or Kandla Grey Sandstone

Smartseal Natural Stone Sealer WET LOOK is a water-based protective sealer that creates a durable, clear silk/satin finish. It can be used on internal and external surfaces made from sandstone**(see exceptions below), limestone, slate, terracotta, quarry and Victorian tiles, brick pavers and any textured stone or masonry surfaces.

Smartseal Natural Stone Sealer WET LOOK is rapid drying and very easy to apply. It will provide protection to the applied surface against oil and water-based stains. 

• Ideal for Natural Stone**(see exceptions below) & Slate
• Provides a Silk/Satin or "Wet-look" finish
• Ok for rough & absorbent surfaces
• Suitable for outdoor or indoor use

Please take a look at the other sealers for natural stone such as the DRY finish Natural Stone Sealer. For a colour enhancing sealer for natural stone that is not a gloss finish, you might want to consider the Natural Stone COLOUR ENHANCER.

*WE DO NOT RECOMMEND USING ON POLISHED STONE & CERAMIC GLAZED SURFACES, AS IT WON'T SOAK INTO THE SURFACE*

**Exceptions to Sandstone suitability: 

Please note this product is not suitable for Kandla Grey (mid and light grey) sandstone

COVERAGE RATIOS: 

Average 5-12 m² per litre depending on the texture and porosity of the surface being sealed.

APPLICATION INSTRUCTIONS:

1. Apply in temperatures above 15°C, but below 23 degrees ensuring the surface is completely dry, clean and free from debris. Apply only if no rain is forecast for at least 8 hours. For best cleaning results use Patio Clean Xtreme.

**If applied to a surface where a "sweep-in" pointing compound has been used with the last 6 months, the natural stone must be fully cleaned with Smartseal Residue Remover prior to sealant application.**

2. Apply the sealer thinly and evenly with a low pressure sprayer, roller, microfibre mop, paint brush or soft cloth. Try not to leave application marks or allow the product to 'pool' or 'puddle' on the surface immediately after application. In the event of over application please ensure all excess is removed within 45 minutes of applying.

3. Once applied, allow minimum 60 minutes drying time before applying the second coat. If possible, apply the product in the opposite direction to try to achieve an even finish. Multiple coats can be applied to achieve the desired finish.

Important Note:  Any areas nearby that are not being sealed should be protected with masking materials. If you are sealing over coloured grouts, carry out that a stain test before proceeding.

QUICK AND RELIABLE DELIVERY THROUGHOUT IRELAND

We offer a delivery service across Ireland for all of our products. 

We provide a comprehensive guarantee of quality and ensuring a reliable nationwide delivery service to all our customers is very important. It does not matter if you live in Dublin, Cork, Sligo or Limerick, our service is as consistent and reliable as can be. This is a testament to the many satisfied customers that have commented on our delivery service over the years. 

We can deliver to another address if you are not going to be in to receive the products. If you notify us with clear delivery instructions, we can also leave with a neighbour or somewhere at your property without a signature.

It is also our aim to monitor our stock levels closely to ensure we can always fulfill demand and make sure products are sent out as soon as possible.

Please read the section relating to deliveries under our Terms and Conditions.